Harley Davidson Grip Removal

The instructions provided with the Tracker grips say to use a long-shank flat tip screwdriver to remove the grip but I found that slicing the grip with a sharp knife and then.

Harley davidson grip removal. The left grip is generally glued to the bar and some of the 1996-newer grips are clamped within the left control button pod or both clamped and glued. Depending on the handlebars you may have to unscrew the left grip but on stock models these usually slide off with a gentle back-and-forth motion. We show you in great detail how to install Harley-Davidson brand heated grips on your Harley.

Slide the new grip onto the handlebar and check that the flanges at the end of the grip line up with the channel in the switch housing. Upon removing the grip check the location of the seal cap. Remove the clamp and position the clutch hand lever assembly away from the handlebar.

Loosen but do not remove the upper and lower switch housing screws 1. Compressed air is your friend but sneaking a thin screw driver under the grip. Upon removing the grip check the location of the seal cap.

The grip is going to be secured by a glue which means that youll have to do some work to get this one removed. Carburetor cleaner between the grip and the handlebar. Be careful and try a heat gun or hair dryer enough to loosen the contact cement you used on the grip and try to rotate the grips.

Remove the clamp and position the clutch hand lever assembly away from the handlebar. Using sandpaper and an adhesive solvent clean the handlebar and remove any remaining adhesive or grip fragments. In order to find the very end squeeze the grip from.

Once clean wipe the bars with some light oil to help the throttle rotate easier. Remove the grip by carefully cutting it away from the handlebar using a sharp blade or knife. No additional cost to you but if you click through and make a purchase we.